Growatt Lithium Ion Battery produced for off-grid and solar application .

Ark 2.56L is a cube design, also called direct stacked .

Modular design and easy to install.

The Growatt ARK battery system has a modular design. Extra batteries can be stacked on top of each other.

AARK-2.5L-A1 low voltage battery (2,56kWh) which can be expended when stacked to 25.6kwh.

The ARK-2.5L-A1 has a capacity of 2.56kWh and a maximum (dis)charge current of 25A.

The nominal voltage is 51,2V and the operating voltage is between 47,2V and 56,8V.

The lithium iron phosphate battery (LFP) is free of cobalt, for example resulting in a less costly battery.

The battery has a cycle life of over 6000.

The battery has a protection rating of IP65 and can be attached to a wall as well as placed on the floor. Install on a floor requires a separate pedestal. The battery is 65cm wide, 26cm deep, 18cm high and weighs 30kgs.

The storage capacity is from 2.56kWh – 23.04kWh (max. 9 batteries).

Important-> When installing on the ARK-2.5L-A1 platform, a 2 platform is required if you will stack more than 5 batteries and the use of a parallel cable (available on request).

Note :

Each set of 5 batteries ARL 2.5L requires one pedestal , for a storage size above 12.8kwh, another pedestal is require to form the second bank.

Lithium ion In lagos
lithium ion price

Quality Lithium ion batteries

 

Reviews

There are no reviews yet.

Be the first to review “Lithium battery Growatt Ark LV 2.5L”

Your email address will not be published. Required fields are marked

MC4 Y Branch Solar Connector

3,600.00
MC4 Y Solar Branch Connector in pair
Add to cart

MidNite Solar MNDC250

The MNDC Plus version of the popular MNDC adds another din rail allowing up to ten din rail mount breakers. Two din rail cover plates and two panel mount plates are included. The panel mount plates allow for mounting the ¾” 125VDC breakers that range from 60 amps to 100 amps. You can also fit the MNDC-GFP80 plus four more panel mount breakers in the enclosure. Another configuration would be one MNDC-GFP, one ¾” panel mount breaker and five din rail breakers as well as the large 125-250A inverter breaker. Mounting is provided for a 500 amp shunt and a MNTBB-R terminal bus bar. Battery negative stud is included as well as a ground busbar.
Read more

Conext Auto Generator Start for XW+/ SW Schneider

200,251.00
The XW+ AGS adds intelligence to generator management, thereby eliminating time spent monitoring batteries and inverter loads.
Add to cart

Schneider Conext Solar Charge Controller 60A- 150Vdc

921,990.00
Mechanical Data Technology: Maximum Power Point Tracking (MPPT) Dimensions: 14.50 x 5.75 x 5.50 inches Weight: 10.75 lbs Enclosure Type: Ventilated Enclosure Material: Sheet Metal Chassis Device Mounting: Vertical Wall Mount - Indoor Only Cable Entry: 7/8" and 1" Knock-Outs & Aluminum Heat-Sink Recommended Wire Size: #6 AWG to #14 AWG Total Power Consumption: 2.5W (Tare) Charger Regulation Method: Three-Stage (Bulk, Absorption, Float)/Two-Stage (Bulk, Absorption) Operating Temperature Range: -20 to +45°C
Add to cart