Growatt Lithium Ion Battery produced for off-grid and solar application .

Ark 2.56L is a cube design, also called direct stacked .

Modular design and easy to install.

The Growatt ARK battery system has a modular design. Extra batteries can be stacked on top of each other.

AARK-2.5L-A1 low voltage battery (2,56kWh) which can be expended when stacked to 25.6kwh.

The ARK-2.5L-A1 has a capacity of 2.56kWh and a maximum (dis)charge current of 25A.

The nominal voltage is 51,2V and the operating voltage is between 47,2V and 56,8V.

The lithium iron phosphate battery (LFP) is free of cobalt, for example resulting in a less costly battery.

The battery has a cycle life of over 6000.

The battery has a protection rating of IP65 and can be attached to a wall as well as placed on the floor. Install on a floor requires a separate pedestal. The battery is 65cm wide, 26cm deep, 18cm high and weighs 30kgs.

The storage capacity is from 2.56kWh – 23.04kWh (max. 9 batteries).

Important-> When installing on the ARK-2.5L-A1 platform, a 2 platform is required if you will stack more than 5 batteries and the use of a parallel cable (available on request).

Note :

Each set of 5 batteries ARL 2.5L requires one pedestal , for a storage size above 12.8kwh, another pedestal is require to form the second bank.

Lithium ion In lagos
lithium ion price

Quality Lithium ion batteries

 

Reviews

There are no reviews yet.

Be the first to review “Lithium battery Growatt Ark LV 2.5L”

Your email address will not be published. Required fields are marked

MidNite Solar MNDC250

The MNDC Plus version of the popular MNDC adds another din rail allowing up to ten din rail mount breakers. Two din rail cover plates and two panel mount plates are included. The panel mount plates allow for mounting the ¾” 125VDC breakers that range from 60 amps to 100 amps. You can also fit the MNDC-GFP80 plus four more panel mount breakers in the enclosure. Another configuration would be one MNDC-GFP, one ¾” panel mount breaker and five din rail breakers as well as the large 125-250A inverter breaker. Mounting is provided for a 500 amp shunt and a MNTBB-R terminal bus bar. Battery negative stud is included as well as a ground busbar.
Read more

Beaver Mini Battery Switch/Disconnect On-Off 12-48V

29,095.00
Battery Switch or battery Disconnect, battery isolator suitable for most residential inverter installation where safety is required.
Add to cart

Sharp solar Panel 445W nu-jd445

227,930.00
Maximum power Pmax 445 Wp Pmax 445wp Open-circuit voltage Voc 49.04V Short-circuit current Isc 11.55A Voltage at point of maximum power Vmpp 41.32 Current at point of maximum power Impp 10.77 Module efficiency nm 20.1% Datasheet 2102_NUJD_445_HC-Mono_Datasheet_10Y_EN
Add to cart

Beaver Battery Charger 48V 15Amp

58,880.00

SPECIFICATION

INPUT

Voltage Range:- 165-285VAC Frequency :- 40-70Hz Current:-  8A (Max.) @full load  

OUTPUT

Max. Output Current:- 4A ±     8A±     10A±     12A±     15A±     15A±     20A± 0.4A     0.8A     1A         1.2A       1.5A       1.5A      20A Output Voltage            240V      120V     96V      72V        48V        36V       24V Max. Output Char.     960W     960W  960W    960W   720W    540W    480W  

PHYSICAL

Dimension (DxWxH):- 300x165x95cm Net Weight:                     3.6                                           3.1

ENVIRONMENT

Operating Humidity:-        5-95% RH (non-condensing) Operating Temperature:-   0-40°C Noise Level:- Less than 50db (A) @CC model & full load
Add to cart

SmartSolar Pluggable Display Victron Energy

The SmartSolar Control Display is a pluggable LCD display for the SmartSolar Charge Controllers. Simply remove the rubber seal that protects the plug on the front of the controller and plug-in the display.
Read more

Voltage Regulator HTND-15KVA Himel Terminal connect Output 230V 1ph

411,999.00
HTND-15KVA (Cabinet) Terminal connect Output 220V With 02Fan
Servo Motor
Add to cart