Schneider Conext Solar Charge Controller 60A- 150Vdc
₦921,990.00
Mechanical Data
Technology: Maximum Power Point Tracking (MPPT)
Dimensions:
14.50 x 5.75 x 5.50 inches
Weight: 10.75 lbs
Enclosure Type: Ventilated
Enclosure Material: Sheet Metal Chassis
Device Mounting: Vertical Wall Mount – Indoor Only
Cable Entry: 7/8″ and 1″ Knock-Outs & Aluminum Heat-Sink
Recommended Wire Size: #6 AWG to #14 AWG
Total Power Consumption: 2.5W (Tare)
Charger Regulation Method: Three-Stage (Bulk, Absorption, Float)/Two-Stage (Bulk, Absorption)
Operating Temperature Range: -20 to +45°C
Schneider Electric Conext MPPT 60 PV Solar Charge Controller
The Xantrex MPPT Solar Charge Controller is a photovoltaic (PV) charge controller that tracks the electrical maximum power point of a PV array to deliver the maximum available current for charging batteries.
The XW SCC can be used with 12, 24, 36, 48, and 60-volt DC battery systems and is able to charge a lower nominal-voltage battery from a higher nominal-voltage array. For example, the XW SCC can charge a 12-volt battery from a 36-volt array. This provides flexibility for installers to use longer wiring runs without compromising efficiency. The XW Solar Charge Controller can be installed (in single or multi-unit configurations) with Xantrex XW Hybrid Inverter/Charger(s) or can be used in other solar energy systems where a solar charge controller is needed.
CCGX WIFI module simple (nano USB) Victron Energy
₦26,737.00
CCGX WiFi module simple (Nano USB), small, low cost. Victron part number BPP900100200
Add to cart
SW Universal DC Breaker Panel
₦203,455.00
The universal DC Breaker Panel is pre-wired for quick installation with a single Conext SW
Add to cart
African Energy 200Watt AFR-200 Monocrystalline Solar Panel
₦114,257.00
Voltage at Pmax (Vmp) [V] 37.77 Current at Pmax (Imp) [A] 5.29 Open Circuit Voltage (Voc) [V] 45.25 Short Circuit Current (Isc) [A] 5.92 Power Tolerance +/- 3% (referenced to the Nominal Output) Maximum System...
Add to cart
Out of stock
Outback SPCIIM-5000-48 Solar O Grid-Hybrid Inverter
Models: SPCIIM-5000-48 • Pure sine wave inverter • Output Power Factor up to 1 • Output Power up to 5000 Watts • Maximum 9 units in parallel / three phase, configurable • Built-in MPPT up...
Read more
Related products
Xantrex Solar Charge Controller PMW C35
₦113,620.00
C60=49,507.84 With display Meter=N75,835.84
C40=45,491.19 with display Meter=N71,819.19
C35=34,044.49 With display Meter=N60,372
Schneider Electric RNWC35 XW C35 35A Charge Controller A Controller for Virtually Any DC Charging Source Previous Part #: C-35 Previousy a Xantrex Product The C Series, including the C35, C40 and C60, is the benchmark of our charge controller lineup. The C35 and C60 are field configurable for 12 and 24 VDC operation. The C40 may be configured for 12, 24, or 48 VDC operation.
C12-12V
C35-12V/24V (55 VDC)
C40-12V/24V/48V (125 VDC)
C60-12V/24V (55 VDC)
with Optional CM/R-50 RemoteDisplayforC35,C40,C60,15mcable
Add to cart
Morningstar SL-10L,12V,SL-10-24V
Technology : PMW
Norminal Battery Voltage : Selectable -12,24
Maximum Current Input/Output:10-20amps
Maximum Solar array Capacity :Weight:0.26KG
Read more
Out of stock
MPPT Solar Charge Controller 96v/60A (SAKO)
MAIN FUNCTION
- full Multi-function LCD Display, easier to check
- Rich operation information shows that PV voltage, current and cumulative power generation
- battery charging voltage are adjustable
- parameter settling power-down save function, automatic memory once setup is complete, easy and fast to use
- various status indications
- with the over-charge, over-load, short circuit and Anti-reverse protection
CM/R-50 Xantrex Remote Display for Solar Charge Controller
₦55,272.00
Remote Display for C35,C40,C60,15mcable
CM/R-50 Xantrex Remote Display For Solar Charge Controller
Digital Meter Mounts Designed for use with C Series Charge Controllers, this digital meter mounts onto the front of a charge controller, or as a remote, it can be installed up to 100 ft (31 m) away. It displays volts, amps, and resettable cumulative amp hours for a solar array, DC loads, or diversion loads, depending on application. The CM/R comes with 50 ft (15 m) or 100 ft (31 m) communication cable for remote installation.
Add to cart
Conext MPPT 80 Solar PV Charge Controller 865-1032
₦1,561,699.00
Conext MPPT 80 Solar PV Charge Controller 865-1032
600V PV input, 48V battery Input, 80A current.
Installing one MPPT 80 600 is faster than installing multiple smaller charge controllers and lowers overall costs further by utilizing fewer PV strings, smaller wiring and conduit, and by eliminating the need for PV combiner boxes and DC circuit breakers.
Add to cart
Outback Radian 7Kw 48V Off-Grid Inverter GS7048E
₦4,523,082.00
Outback Radiant GE7048E
230V
56.7kg
radianseries_7048e_3548e_specsheet
Add to cart
radianseries_7048e_3548e_specsheet
Xantrex Solar Charge Controller PMW C60/C40/C35/C12
₦100,622.00
C60=49,507.84 With display Meter=N75,835.84
C40=45,491.19 with display Meter=N71,819.19
C35=34,044.49 With display Meter=N60,372
Schneider Electric RNWC35 XW C35 35A Charge Controller A Controller for Virtually Any DC Charging Source Previous Part #: C-35 Previousy a Xantrex Product The C Series, including the C35, C40 and C60, is the benchmark of our charge controller lineup. The C35 and C60 are field configurable for 12 and 24 VDC operation. The C40 may be configured for 12, 24, or 48 VDC operation.
C12-12V
C35-12V/24V (55 VDC)
C40-12V/24V/48V (125 VDC)
C60-12V/24V (55 VDC)
with Optional CM/R-50 RemoteDisplayforC35,C40,C60,15mcable
Add to cart
Morningstar TS-45
Technology : PMW
Norminal Battery Voltage :
Selectable -12,24,36,48V
Maximum Current Output :60amps
Open Circuit Voltage:125VDC
Status Display:LED with Optional meter
Weight:1.6KG
Read more
Morningstar TS-MPPT-60
Technology : MPPT
Norminal Battery Voltage :
Selectable -12,24,36,48V
Maximum Current Output :60amps
Maximum Solar array Capacity :
@12V=800watts,@24V=1600watts,
@48V=3200watts
Open Circuit Voltage:150VDC
Status Display:LED with Optional meter
Weight:4.2KG
Read more
OutBack Power FM100-300VDC FLEXmax 100A MPPT Solar Charge Controller
₦1,169,090.00
FM100-300VDC-AFCI Specifications:
Nominal battery system voltage: 24, 36, & 48 Volts DC
Charging range output: 20 - 68 Volts DC
Controller type: MPPT
Minimum battery bank size: 100 Amp-hours
Maximum continuous output current: 100 Amps
Maximum input current: 64 Amps
Maximum array power (24V / 36V / 48V): 3500 / 5250 / 7000 Watts
Maximum PV system voltage: 300 Volts DC
Operating input voltage range: 30 - 290 Volts DC
Peak efficiency: 98.8% at 48VDC
Remote display & controller: MATE3s compatible (purchased separately)
Data logging: 128 days
Enclosure protection rating: IP54
Weight: 19.75 pounds (8.9 kg)
Dimensions (H x W x D): 23.0 x 8.8 x 6.0 inches
Certifications: UL 1741, CSA C22.2 No. 107.1, IEC 62109-1
FM100_specsheet
Add to cart
Reviews
There are no reviews yet.